Information injection-pump assembly
BOSCH
9 400 615 991
9400615991
ZEXEL
101691-6131
1016916131
MITSUBISHI
ME088512
me088512
Rating:
Service parts 101691-6131 INJECTION-PUMP ASSEMBLY:
1.
_
6.
COUPLING PLATE
7.
COUPLING PLATE
8.
_
9.
_
11.
Nozzle and Holder
ME080082
12.
Open Pre:MPa(Kqf/cm2)
17.2{175}
15.
NOZZLE SET
Include in #1:
101691-6131
as INJECTION-PUMP ASSEMBLY
Include in #2:
104745-8140
as _
Cross reference number
Zexel num
Bosch num
Firm num
Name
101691-6131
9 400 615 991
ME088512 MITSUBISHI
INJECTION-PUMP ASSEMBLY
6D31T K 14BE INJECTION PUMP ASSY PE6A PE
6D31T K 14BE INJECTION PUMP ASSY PE6A PE
Information:
Engine Crankshaft Will Not Turn
Possible Causes/Corrections Low Or No Battery VoltageCheck battery voltage. If battery voltage is less than 8 volts for a 12 volt system, or 16 volts for a 24 volt system, put a charge to the battery. If battery will not hold a charge, load test the battery as shown in the Electrical System of the Testing and Adjusting Section of this Service Manual. Defective Switch, Defective Wiring Or Connection In Switch CircuitWith ignition switch in START position, check voltage at switch connection on starter solenoid. If there is no voltage, or if the voltage is low at this connection, check wiring, connections, ignition switch, and magnetic switch (if used). Defective Cable Or Connection; Battery To StarterWith ignition switch in the START position, check voltage at connection of battery cable to starter. If there is no voltage, or if the voltage is low at this connection and there is good voltage at the battery, check for defective cable or connection between the
Possible Causes/Corrections Low Or No Battery VoltageCheck battery voltage. If battery voltage is less than 8 volts for a 12 volt system, or 16 volts for a 24 volt system, put a charge to the battery. If battery will not hold a charge, load test the battery as shown in the Electrical System of the Testing and Adjusting Section of this Service Manual. Defective Switch, Defective Wiring Or Connection In Switch CircuitWith ignition switch in START position, check voltage at switch connection on starter solenoid. If there is no voltage, or if the voltage is low at this connection, check wiring, connections, ignition switch, and magnetic switch (if used). Defective Cable Or Connection; Battery To StarterWith ignition switch in the START position, check voltage at connection of battery cable to starter. If there is no voltage, or if the voltage is low at this connection and there is good voltage at the battery, check for defective cable or connection between the
Have questions with 101691-6131?
Group cross 101691-6131 ZEXEL
Mitsubishi
Mitsubishi
101691-6131
9 400 615 991
ME088512
INJECTION-PUMP ASSEMBLY
6D31T
6D31T